Maintenance
Version 1.0.4 - 2020-08-04 57Translation of original instruction
MT60 EN
MT60_GB_5.fm
6.3 Inspection and maintenance
The type and level of wear depends to a large extent on the individual usage and operating
conditions. Any indicated intervals therefore are only valid for the corresponding approved con-
ditions.
Technical specification on page 18
Interval Where? What? How?
Start of work,
after every
maintenance or
repair work
Milling machine
Safety check on page 14
Start of work,
after every
maintenance or
repair work
Moving machine parts
Oiling
All mobile machine parts such as guides, feed screws,
spindle nuts must be oiled in regular intervals.
Always slightly oil bare surfaces.
Lubricate the cross table lifting spindle with bearing
grease.
Oil at these lubricating point positions.
Img.6-1: Oiler cup
To Next Page
Loading...
