Optimum OPTImill MT 60 - Positioning the Coordinate Points; Coordinate Points on a Circle or Arc

Operation
Version 1.0.4 - 2020-08-04 47Translation of original instruction
DPA21 EN
DPA21_GB_3.fm
5.6.2 Positioning the Coordinate Points
INFORMATION
Press the button to temporarily interrupt the function. The display returns to the normal
display status. Press the 0 key again to continue with the function.
To exit from the function, press the button.
5.7 Coordinate Points on a Circle or Arc
Creates a circle or arc within a coordinate system, along which a specified number of uniformly
spaced coordinate points are defined.
The set coordinate points on the circle or arc run counterclockwise. Coordinate point 2 is
located counterclockwise of coordinate point 1.
 The parameters are displayed in the Rotation Speed field.
 The last entered value of each parameter is shown in the row of the X axis.
 Entering a new value is specified in the row of the Y axis.
Parameters Description
1LHo Coordinate point no.: X-Y
2LHo Coordinate point no.: Y-Z
3LHo Coordinate point no.: X-Z
To select the desired coordinate point, press the button.
To select the previous coordinate point, press the button.
The machine axes proceed until the positions of the selected coordinate point read 0.000.