Optimum OPTImill MT 60 - Coordinate Points Along a Diagonal Line; Entering the Parameters

Operation
Version 1.0.4 - 2020-08-0446 Translation of original instruction
DPA21
EN
DPA21_GB_3.fm
5.6 Coordinate points along a diagonal line
Creates a line within a coordinate system, along which a specified number of uniformly spaced
coordinate points are defined.
 The parameters are displayed in the Rotation Speed field.
 The last value entered for each parameter is displayed in the X axis row.
 Enter new values in the Y axis row.
5.6.1 Entering the Parameters
Parameters Description
1 - 1 L_A Angle of the line on the coordinate axis: X-Y
2 - 1 L_A Angle of the line on the coordinate axis: Y-Z
3 - 1 L_A Angle of the line on the coordinate axis: X-Z
Press the key to select X-Y, Y-Z or X-Z as the coordinate axis.
To enter the angle of the line, use the numeric keys and confirm with the key.
Parameters Description
1 - 2 L_d Length of the line: X-Y
2 - 2 L_d Length of the line: Y-Z
3 - 2 L_d Length of the line: X-Z
To enter the length of the line, use the numeric keys and confirm with the key.
Parameters Description
1 - 3 .H Number of coordinate points: X-Y
2 - 3 .H Number of coordinate points: Y-Z
3 - 3 .H Number of coordinate points: X-Z
To enter the number of coordinate points, use the numeric keys
and confirm with the key.
L
L
L