Optimum OPTImill MT 60 - Positioning to Coordinate Points

Operation
Version 1.0.4 - 2020-08-04 49Translation of original instruction
DPA21 EN
DPA21_GB_3.fm
5.7.2 Positioning to coordinate points
INFORMATION
Press the button to temporarily interrupt the function. The display returns to the normal
display status. Press the 0 key again to continue with the function.
Press the button to exit from the function.
Parameter Description
1 - 5 E_A End angle: X-Y
2 - 5 E_A End angle: Y-Z
3 - 5 E_A End angle: X-Z
To enter the end angle on the coordinate plane, use the numeric keys
and confirm with the key.
Parameter Description
1Cho Coordinate point no.: X-Y
2CHo Coordinate point no.: Y-Z
3CHo Coordinate point no.: X-Z
To select the desired coordinate point, press the button.
Press button to select the desired coordinate point.
The machine axes will proceed until the positions of the selected coordinate axes read 0.000.