Replacing a ZS3-4 PCIe Card or Riser
c.
Press down on the cover with both hands until both latches engage.
8.
Push the release tabs on the side of each rail and slowly push the storage
controller into the rack, making sure no cables obstruct the path of the
controller.
9.
Reconnect all cables to their original ports, referring to the labels previously
added as a guide. For cabling details, see the Oracle ZFS Storage Appliance
Cabling Guide.
10.
Connect the power cords to the power supplies.
11.
Verify that standby power is on, indicated by the Power/OK status indicator
flashing on the front panel about two minutes after the power cords are plugged
in.
Servicing the ZS3-4 Controller 107
To Next Page
Loading...
Need help?
General