Prepare the Server
28 SPARC T5-4 Server Installation Guide • July 2015
■
“ESD Precautions” on page 27
■
Server Service
Prepare the Server
Caution - Do not attempt to move the server alone without a lift. For a one-person installation,
the components must be removed and a lift must be used. For a two-person installation, the
main components must be removed and a lift is optional.
1.
Remove the server from the box.
See “Shipping Kit (Part Number 7069640)” on page 23.
2.
Remove all of the processor modules, the main module, the power supplies, and
the fan modules from the server.
Refer to the service manual for detailed instructions.
3.
Determine your next step:
■
For a one-person installation, place the server on a mechanical lift.
■
For a two-person installation, place the server on a mechanical lift if one is
available.
4.
Remove the PCIe card carriers if there are PCIe cards that need to be installed.
Refer to the service manual for detailed instructions.
5.
Install the server in the rack.
See “Install the Server” on page 53.
Related Information
■
“Physical Specifications” on page 17
■
“Handling Precautions” on page 26
■
“ESD Precautions” on page 27
To Next Page
Loading...
Need help?
General