Oracle SPARC T5-4 Installation Guide

Identifying Ports
60 SPARC T5-4 Server Installation Guide • July 2015
■
“Assign a Static IP Address to the NET MGT Port” on page 80
Gigabit Ethernet Ports
Four RJ-45 10-Gigabit full-duplex auto-negotiating Ethernet ports (NET0, NET1, NET2,
NET3) are located on the system rear panel. See “Rear Panel Components” on page 14. The
Ethernet interfaces operate at 100 Mbit/sec, 1000 Mbit/sec, and 10000 Mbit/sec.
Pin Signal Description Pin Signal Description
1 Transmit/Receive Data 0 + 5 Transmit/Receive Data 2 –
2 Transmit/Receive Data 0 – 6 Transmit/Receive Data 1 –
3 Transmit/Receive Data 1 + 7 Transmit/Receive Data 3 +
4 Transmit/Receive Data 2 + 8 Transmit/Receive Data 3 –
Related Information
■
“Server Overview” on page 12
■
“Rear Panel Components” on page 14
■
“Connect the Ethernet Network Cables” on page 63
VGA Port
The server has two 15-pin VGA video ports, one port on the front and one on the back of the
server. See “Front Panel Components” on page 13 and “Rear Panel Components” on page 14.
Use a HD-15 video cable to connect to a video adapter to achieve the required connection.
Note - Only one of the two ports can be used at a time. The rear VGA port is disabled by
default. To enable the rear port and disable the front port, you must enable the Oracle ILOM
VGA_REAR_PORT policy: -> set /SP/policy VGA_REAR_PORT=enabled.

Oracle SPARC T5-4 Specifications

General

Brand	Oracle
Model	SPARC T5-4
Category	Server
Language	English