Installing the Server 29
Installing the Server
These topics describe how to install the server into a rack equipped with square mounting holes.
If you are installing the server into a rack equipped with round mounting holes, see “Determine
Correct Rackmount Hardware” on page 36.
Note - If the rackmount kit came with its own instructions, use the instructions instead of the
instructions in this chapter. After performing the server installation, proceed to “Powering On
the Server for the First Time” for first-time power on.
Step Description Links
1. Ensure that your rack is compatible with the
server requirements.
“Rack Compatibility ” on page 30
2. Determine the correct rackmounting hardware
and install the hardware.
“Determine Correct Rackmount
Hardware” on page 36
“Mark the Rackmounting Location” on page 36
“Install the Rackmount Hardware” on page 37
3. (Optional) Install the CMA. There are two
types of CMAs. Note which type you have for
applicable instructions.
“Installing the CMA” on page 42
4. If you are installing the server into a rack that
will be shipped to another location, install the
shipping brace assembly.
“Shipping Brace Assembly” on page 48
5. Install the server in the rack. “Install the Server” on page 53
6. Review cabling requirements and port
information. Attach data and management
cables to the server.
“Connecting the Server Cables”
7. Configure the Oracle ILOM SP and power on
the server for the first time.
“Powering On the Server for the First Time”
Related Information
■
“Understanding the Server”
■
“Connecting the Server Cables”
To Next Page
Loading...
Need help?
General