Installing the Shipping Brace Assembly
48 SPARC T5-4 Server Installation Guide • July 2015
Related Information
■
“CMA Kit (CMA Comb, Part Number 7069793)” on page 43
■
“Determine Correct Rackmount Hardware” on page 36
Installing the Shipping Brace Assembly
This shipping brace assembly is included in the shipping kit with the CMA comb, part number
7069640. Use these procedures if you are installing the server into an equipment rack that will
be shipped to another location.
Note - These procedures describe how to install the server into a rack with square mounting
holes. If you are installing the server into a rack with round mounting holes, see “Determine
Correct Rackmount Hardware” on page 36.
■
“Determine Correct Shipping Brace Fasteners” on page 50
■
“Install the Top Rear Braces ” on page 50
■
“Install the Bottom Rear Shipping Brace ” on page 51
Related Information
■
“Rack Compatibility ” on page 30
■
“Determine Correct Rackmount Hardware” on page 36
■
“Mark the Rackmounting Location” on page 36
■
“Install the Server” on page 53
Shipping Brace Assembly
The shipping brace assembly provides extra shock and vibration protection. Use this kit when
installing the server into a vehicle, or when you are installing the server into an equipment rack
that will be shipped to another location for final installation.
To Next Page
Loading...
Need help?
General