Stabilize the Rack
32 SPARC T5-4 Server Installation Guide • July 2015
Related Information
■
“Physical Specifications” on page 17
■
“Handling Precautions” on page 26
■
“Stabilize the Rack” on page 32
Stabilize the Rack
Caution - To reduce the risk of personal injury, stabilize the rack by extending all anti-tilt
devices before installing the server.
Refer to the rack documentation for detailed instructions for the following steps.
1.
Read the rack cautions and stabilize the rack.
See “Rack Cautions” on page 31.
2.
Open and remove the front and rear doors from the rack.
3.
To prevent the rack from tipping during the installation, stabilize the rack using
all anti-tilt mechanisms provided.
4.
If there are leveling feet beneath the rack to prevent it from rolling, extend these
leveling feet fully downward to the floor.
Related Information
■
“Rackmount Kit (Part number 7069640)” on page 32
■
“Rackmount Kit (Part number 350-1662-02)” on page 34
■
Rack documentation
■
SPARC T5-4 Server Safety and Compliance Guide
■
“Rack Compatibility ” on page 30
■
“Rack Cautions” on page 31
Rackmount Kit (Part number 7069640)
This rackmount kit includes the CMA comb. If your rackmount kit includes the multi-piece
CMA, see “Rackmount Kit (Part number 350-1662-02)” on page 34.
To Next Page
Loading...
Need help?
General