Power on the System for the First Time
70 SPARC T5-4 Server Installation Guide • July 2015
Power on the System for the First Time
1.
At the terminal device, log in to the SP as root with a password of changeme.
XXXXXXXXXXXXXXXX login: root
Password: changeme ( nothing
displayed)
. . .
->
After a brief delay, the Oracle ILOM prompt is displayed (->).
Note - To enable first-time login and access to Oracle ILOM, a default Administrator account
and its password are provided with the system. To build a secure environment, you must change
the default password (changeme) for the default Administrator account (root) after your initial
login to Oracle ILOM. If this default Administrator account has been changed, contact your
system administrator for an Oracle ILOM user account with Administrator privileges.
For more information about the administration tasks such as changing passwords, adding
accounts, and setting account privileges, refer to the Oracle ILOM documentation.
Note - By default, the SP is configured to use DHCP to obtain an IP address. If you plan
to assign a static IP address to the SP, see“Assign a Static IP Address to the NET MGT
Port” on page 80 for more instructions.
2.
Power on the server using one of the following methods:
■
Press the power button.
■
At the Oracle ILOM prompt, type:
-> start /System
Are you sure you want to start /System (y/n)? y
The server initialization might take several minutes to complete.
To cancel the initialization, press the #. (Hash+Dot) keys to return to the Oracle ILOM prompt.
Then type: stop /System
Note - In Oracle ILOM 3.1, the name space for /SYS was replaced with /System. You can use
the legacy name in a command at any time, but to expose the legacy name in the output, you
must enable it with -> set /SP/cli legacy_targets=enabled. For more information, see the
Oracle ILOM 3.1 documentation.
To Next Page
Loading...
Need help?
General