Oracle ILOM System Console
Powering On the Server for the First Time 71
3.
(Optional) Redirect the host output to display on the serial terminal device.
-> start /HOST/console
Are you sure you want to start /SP/console (y/n)? y
Serial console started.
. . .
4.
(Optional) You can execute other Oracle ILOM commands while the server
initializes.
a.
To display the Oracle ILOM prompt, press the #. (Hash+Dot) keys.
b.
To see information about available Oracle ILOM commands, type: help
To see information about a specific command, type help command-name
c.
To return to displaying host output from the server initialization, type:
-> start /HOST/console
5.
Continue with the installation by installing the OS.
See “Configure the Preinstalled OS” on page 72.
Related Information
■
“Connect the SER MGT Cable” on page 62
■
“Oracle ILOM System Console” on page 71
■
“Configure the Preinstalled OS” on page 72
■
“Reach a State to Install a Fresh OS (Oracle ILOM CLI)” on page 73
■
“Reach a State to Install a Fresh OS (Oracle ILOM Web Interface)” on page 75
Oracle ILOM System Console
When power is first applied to the system, the boot process begins under the control of the
Oracle ILOM system console. The system console displays status and error messages generated
by firmware-based tests that are run during system startup.
Note - To see these status and error messages, connect a terminal or terminal emulator to the
SER MGT before applying power to the server.
To Next Page
Loading...
Need help?
General