Identifying Ports
Connecting the Server Cables 59
Pin Signal Description Pin Signal Description
4 Ground 8 Clear to Send
Related Information
■
“Server Overview” on page 12
■
“Front Panel Components” on page 13
■
“Rear Panel Components” on page 14
■
“Connect the SER MGT Cable” on page 62
■
“Connect a Terminal or Emulator to the SER MGT Port” on page 68
NET MGT Port
The NET MGT RJ-45 port, located on the rear panel, provides an optional Ethernet connection
to the SP. The NET MGT port is an optional connection to the Oracle ILOM SP. The SP NET
MGT port uses an RJ-45 cable for a 10/100BASE-T connection. If your network does not use
a DHCP server, this port will not be available until you configure network settings through the
SER MGT port. See “Rear Panel Components” on page 14.
Pin Signal Description Pin Signal Description
1 Transmit Data + 5 Common Mode Termination
2 Transmit Data – 6 Receive Data –
3 Receive Data + 7 Common Mode Termination
4 Common Mode Termination 8 Common Mode Termination
Related Information
■
“Server Overview” on page 12
■
“Rear Panel Components” on page 14
■
“Connect the NET MGT Cable” on page 63
To Next Page
Loading...
Need help?
General