Remove the Bottom Rear Shipping Brace
52 SPARC T5-4 Server Installation Guide • July 2015
2.
Install two No. 2 Phillips screws in each side of the shipping brace.
Remove the Bottom Rear Shipping Brace
Remove the bottom shipping brace after the server rack reaches its final destination.
1.
Remove the four screws that secure the bottom shipping brace to the rack.
2.
Slide the shipping brace out from the rear of the rack.
Related Information
■
“Tools Needed for Installation” on page 27
■
“Rack Compatibility ” on page 30
■
“Determine Correct Rackmount Hardware” on page 36
■
“Mark the Rackmounting Location” on page 36
To Next Page
Loading...
Need help?
General