OPTIMOD SURROUND PROCESSOR INSTALLATION
2-51
9. To change the Terminal Port:
Command Response
TP XXXXX «
(valid terminal port)
TP: xxxxx entered«
(invalid terminal port)
ERROR. Using TP: yyyyy«
TP?« Using TP: yyyyy«
In the above table: XXX.XXX.XXX.XXX =s the specified terminal port;
yyy.yyy.yyy.yyy = the present terminal port in use.
Port 23 is the factory default.
Valid ports are defined according to existing standards. Any out-of-range or in-
valid characters render the whole argument invalid.
10. To change the Modem Init string:
Applies only for modem connections (via 8685’s Serial 1 port)
Command Response
MO ATF0S0=4« MO[ATF0S0=4] entered«
MO?
Using MO[ATF0S0=4]«
The 8685 appends CR+LF to the modem init string as transmitted to a modem
(physically connected to Serial 1). The 8685 will not perform any case conversion
to the argument (i.e., lower case arguments will be transmitted to the modem as
lower case).
11. To change the RS-232 serial port Interface Type:
Command Response
TY M|D|A«
(valid argument)
Ty: Modem|Direct|ASCII entered«
(invalid argument)
ERROR. Using Ty: M|D|A«
TY?« Using Ty: Modem|Direct|ASCII«
12. To fetch diagnostic information from the 8685:
This provides a status report indicating essential information:
Command Response
ST« 8685 V 1.0.x.xx
Station Name: undefined
Access Level: 0: all access
Bootup: Sat Jan 01 02:26:37 2000
Ethernet Adapter's MAC Address: xx-xx-
To Next Page
Loading...
