120
Addresses and codes list
12.9.2 Output signals list
Assignment number Signal name Monitor target Address Corresponding bit
0 Not used – – –
8 ALM-RST_R
I/O status 1 (lower)
369
(0171h)
bit8
14 INFO-CLR_R blt14
16 HMI_R
I/O status 1 (upper)
368
(0170h)
bit0
22 TL_R bit6
25 EXT-ERROR_R bit9
58 FWD (START/STOP)_R
*1
I/O status 2 (upper)
370
(0172h)
bit10
59 REV (RUN/BRAKE)_R
*1
bit11
64 M0_R
I/O status 3 (lower)
373
(0175h)
bit0
65 M1_R bit1
66 M2_R bit2
72 STOP-MODE (FWD/REV)_R
*1
bit8
80 R0_R
I/O status 3 (upper)
372
(0174h)
bit0
81 R1_R bit1
82 R2_R bit2
83 R3_R bit3
129 ALM-A
I/O status 5 (lower)
377
(0179h)
bit1
130 ALM-B bit2
134 MOVE bit6
135 INFO bit7
136 SYS-BSY bit8
140 TLC bit12
141 VA bit13
147 SPEED-OUT
*2
I/O status 5 (upper)
376
(0178h)
bit3
148 DIR bit4
168 MPS I/O status 6 (lower)
379
(017Bh)
bit8
226 INFO-DRVTMP
I/O status 8 (lower)
383
(017Fh)
bit2
228 INFO-OVOLT bit4
229 INFO-UVOLT bit5
231 INFO-LOAD bit7
232 INFO-SPD bit8
233 INFO-SET-E bit9
236 INFO-DRV bit12
239 INFO-NET-E bit15
243 INFO-REV
I/O status 8 (upper)
382
(017Eh)
bit3
244 INFO-TRIP bit4
245 INFO-ODO bit5
248 INFO-TRQ-DE bit8
249 INFO-SPD-DE bit9
250 INFO-PTIME bit10
251 INFO-PCOUNT bit11
252 INFO-DSLMTD bit12
253 INFO-IOTEST bit13
254 INFO-CFG bit14
255 INFO-RBT bit15
*1
If the 3-wire mode is selected with the "Operation input mode selection" parameter, the signal in the parentheses ( ) will be
applied.
*2
The SPEED-OUT output cannot be assigned to the remote output.
To Next Page
Loading...
