Oriental motor BLH Series - Parameter List

31
Parameter
9.1 Parameter list
Parameter name Setting range Factory setting Update
Reference
page
Operation data extension setting
Speed upper limit 80 to 3150 r/min 3150
B
P.35
Speed lower limit 80 to 3150 r/min 80
Torque limiting maximum value 0 to 200% 200
External setting method
0: External analog setting device
1: PWM signal input
0 C
External analog operation speed command gain 0 to 3150 r/min/V 640
A
External analog operation speed command oset −1500 to +1500 r/min 0
External analog torque limiting gain 0 to 200%/V 43
External analog torque limiting oset
- 100 to +100% 0
Operation and I/O action
Impact softening lter
0: No lter
1: Filter 1
2: Filter 2
0 B
P.39
Deceleration mode selection
0: Deceleration stop 1
1: Deceleration stop 2
2: Deceleration stop 3
0
C
Motor rotation direction
0: +=CCW
1: +=CW
1
Operation input mode selection
0: 2-Wire mode
1: 3-Wire mode
1
VA detection width 1 to 400 r/min 200 A
Alarm and information settings
Overload alarm detection time 0.1 to 10.0 s 10.0 A
P.41
Prevention of operation at power-on alarm
0: Disable
1: Enable
1 C
Information auto clear
0: Disable
1: Enable
1
A
Driver temperature information 40 to 85 °C 85
Overvoltage information 18.0 to 38.0 VDC 38.0
Undervoltage information 18.0 to 38.0 VDC 18.0
Load information
0: Disable
1 to 200%
0
Speed information
0: Disable
1 to 5200 r/min
0
RS-485 communication error information 1 to 10 times 3
Tripmeter information
0.0: Disable
0.1 to 99999999.9 kRev
0.0
Odometer information
0.0: Disable
0.1 to 99999999.9 kRev
0.0
Main power supply time information
0: Disable
1 to 999999999 min
0
Main power supply count information
0: Disable
1 to 999999999 times
0
Rotation amount meter information (positive side) −2147483648 to +2147483647 rev +2147483647
Rotation amount meter information (negative side) −2147483648 to +2147483647 rev −2147483648