Oriental motor BLH Series - Grounding; Connecting the USB Cable (CN4)

14
Connection
6.6 Grounding
The wire used to ground the motor and driver must be as thick and short to the grounding point as possible so that no
potential dierence is generated. Choose a large, thick and uniformly conductive surface for the grounding point.
z
Grounding the motor
Connect the grounding wire along with a set
screw to the grounding point, using a shakeproof
washer.
For the 15 W type motor, remove the paint from
the mounting surface of the geared motor, and
install it to a metal surface that has grounded.
z
Grounding the driver
Install the driver to a metal surface that
has grounded.
6.7 Connecting the USB cable (CN4)
When the
MEXE02
is used, connect the USB cable
to the USB connector.
Specications of USB cable
Specication USB2.0 (full speed)
Cable Length: 3 m (9.8 ft.) or less Shape: A to mini B
Note
•
Connect the driver and PC directly with the USB cable without using a hub or extension cable.
•
In large electrically noisy environments, use the USB cable with a ferrite core or install a ferrite core to the USB cable.