Oriental motor BLH Series - Names and Functions of Parts

8
Preparation
4.5 Names and functions of parts
This section explains the name and function for each part of the driver.
CN1 CN2
+
-
CN3
CN6
CN5
C-DAT
C-ERR
Motor connector (CN3)
LED (PWR/ALM)
Power supply connector (CN1)
I/O signal connector (CN2)
RS-485 communication connector (CN5)
RS-485 communication connector (CN6)
USB connector (CN4)
Termination resistor switch (TERM.)
Address number setting switch (ID)
LED (C-DAT/C-ERR)
CN4
PWR/ALM
IDTERM.
NO
Name Sign Description
Power supply connector CN1 Connects the power supply cable.
I/O signal connector CN2 Connects the I/O signal cable to connect with an external control device.
Motor connector CN3 Connects the motor cable.
USB connector CN4 Connects a PC in which the
MEXE02
has been installed.
RS-485 communication connector
CN5
Connects a communication cable to connect with an external control device.
Or connect to a dierent driver with a daisy chain.
CN6
LED
PWR/ALM
This LED is lit in green while the power is supplied.
If an alarm is generated, this LED will blink in red.
If information is generated, it will blink in orange.
C-DAT
C-ERR
This LED is lit in green when the driver communicates with the master station
properly via RS-485 communication.
This LED is lit in red when an error occurs in communication with the master station
via RS-485 communication.
Address number setting switch ID
Sets the address number when used via RS-485 communication.
Factory setting: 1 (0 to F)
Termination resistor switch TERM.
Sets the termination resistor (120
Ω
) of RS-485 communication.
Factory setting: OFF (OFF: Disabled, ON: Enabled)