Oriental motor BLH Series - I;O Signals Assignment List

119
Addresses and codes list
12.9 I/O signals assignment list
To assign signals via RS-485 communication, use the "Assignment number" in the table instead of the signal names.
12.9.1 Input signals list
Assignment number Signal name Monitor target Address Corresponding bit
0 Not used – – –
8 ALM-RST
I/O status 1 (lower)
369
(0171h)
bit8
14 INFO-CLR blt14
16 HMI
I/O status 1 (upper)
368
(0170h)
bit0
22 TL bit6
25 EXT-ERROR
*1
bit9
58 FWD (START/STOP)
*2
I/O status 2 (upper)
370
(0172h)
bit10
59 REV (RUN/BRAKE)
*2
bit11
64 M0
I/O status 3 (lower)
373
(0175h)
bit0
65 M1 bit1
66 M2 bit2
72 STOP-MODE (FWD/REV)
*2
bit8
80 R0
I/O status 3 (upper)
372
(0174h)
bit0
81 R1 bit1
82 R2 bit2
83 R3 bit3
*1
The EXT-ERROR input cannot be assigned to the remote input.
*2
If the 3-wire mode is selected with the "Operation input mode selection" parameter, the signal in the parentheses ( ) will be
applied.