Oriental motor BLH Series - I;O Signals Assignment List

53
Parameter
9.9 I/O signals assignment list
To assign signals via RS-485 communication, use the "Assignment number" in the table instead of the signal names.

Input signal
Assignment
number
Signal name
Assignment
number
Signal name
Assignment
number
Signal name
0 Not used 58 FWD (START/STOP)
*2
80 R0
8 ALM-RST 59 REV (RUN/BRAKE)
*2
81 R1
14 INFO-CLR 64 M0 82 R2
16 HMI 65 M1 83 R3
22 TL 66 M2
25 EXT-ERROR
*1
72 STOP-MODE (FWD/REV)
*2
*1
The EXT-ERROR input cannot be assigned to the remote input.
*2
If the 3-wire mode is selected with the "Operation input mode selection" parameter, the signal in the parentheses ( ) will be
applied.

Output signal
Assignment
number
Signal name
Assignment
number
Signal name
Assignment
number
Signal name
0 Not used 129 ALM-A 226 INFO-DRVTMP
8 ALM-RST_R 130 ALM-B 228 INFO-OVOLT
14 INFO-CLR_R 134 MOVE 229 INFO-UVOLT
16 HMI_R 135 INFO 231 INFO-LOAD
22 TL_R 136 SYS-BSY 232 INFO-SPD
25 EXT-ERROR_R 140 TLC 233 INFO-SET-E
58 FWD (START/STOP)_R
*1
141 VA 236 INFO-DRV
59 REV (RUN/BRAKE)_R
*1
147 SPEED-OUT
*2
239 INFO-NET-E
64 M0_R 148 DIR 243 INFO-REV
65 M1_R 168 MPS 244 INFO-TRIP
66 M2_R 245 INFO-ODO
72 STOP-MODE (FWD/REV)_R
*1
248 INFO-TRQ-DE
80 R0_R 249 INFO-SPD-DE
81 R1_R 250 INFO-PTIME
82 R2_R 251 INFO-PCOUNT
83 R3_R 252 INFO-DSLMTD
253 INFO-IOTEST
254 INFO-CFG
255 INFO-RBT
*1
If the 3-wire mode is selected with the "Operation input mode selection" parameter, the signal in the parentheses ( ) will be
applied.
*2
The SPEED-OUT output cannot be assigned to the remote output. Also, the logic level setting cannot be inverted.