Oriental motor BLH Series - 8 Guidance

27
Guidance
8 Guidance
If you are new to this product, read this chapter to understand the operating methods along with the operation ow.
This is an example how to set operation data and parameters to the driver and operate the motor using a host controller.
Note
•
Before operating the motor, check the surrounding conditions to ensure safety.
•
After changing a parameter, it may be required to perform Conguration or turn on the driver power again in order
to update the new setting.
Refer to p.97 for details about the update timing.
STEP1 Checking the installation and connection
➡
STEP2 Setting switches
➡
This operation is performed under the following
conditions.
•
Number of drivers connected: 1 unit
•
Address number: 1 (set by the switch)
•
Transmission rate: 115,200 bps
•
Termination resistor: Set to be enable
STEP3 Setting the communication parameters
➡
STEP4 Turning on the power supply again
➡
STEP5 Operating the motor
➡
STEP6 Checking the operation
STEP1 Checking the installation and connection
Connection diagram
CN1 CN2
+
-
CN3
CN6
CN5
C-DAT
C-ERR
CN4
PWR/ALM
IDTERM.
NO
24 VDC
Driver
Motor
Host controller
MEXE02
DC power supply
Connected to
the CN1
Connected to the CN5 or CN6
RS-485 communication cable
Connected to
the CN3
Connected to
the CN4

CN5/CN6 pin assignment
Pin No. Signal name Description
1 TR+ RS-485 communication signal (+)
2 TR− RS-485 communication signal (
- )
3 GND GND