4) Check to ensure the lock is securely engaged.
Power back angle adjustment
The back angle is adjusted as needed by using this seat function (see page75).
7.5 Getting in and transferring
CAUTION
Incorrect handling when getting in
Falling, tipping over due to incorrect handling
► Turn the control unit off while getting in and out, in order to avoid accidental driving.
► Always place the seat in a horizontal position.
► Note that the armrests are not capable of bearing full body weight, and therefore must not be used for getting
into or out of the wheelchair.
► Always put on a lap belt when driving.
CAUTION
Incorrect handling when getting in
Crushing, pinching, impacts due to incorrect handling
► Do not reach into the danger area with your fingers when folding the legrest or footplates up or down.
► Never step on the footplates when getting in and out.
► Note projecting edges.
The modular design of the power wheelchair and the ease with which you can remove the side panels and legrests
make it easy to get into and out of the wheelchair from the side or from the front.
Users can choose the method for getting into and out of the wheelchair which is most suitable for them.
24
Getting in from the front
1) Turn the control device off.
2) Fold up the foot supports (see fig.24; item1).
If needed, swing the leg supports aside or remove
them (see page20).
3) Have an attendant assist you or use a transfer lifter
to get into and out of the power wheelchair.
4) Swing the leg supports in and fold down the foot
supports (see page20).
Getting in from the side (alternative option)
1) Turn the control device off.
2) Remove the side panel (see page17).
3) If needed: Remove the corresponding leg support
(see page20).
4) Get into or out of the power wheelchair from the
side. A ramp makes this easier.
5) Reinstall the leg support and side panel.
25490E75=1_C
Use
To Next Page
Loading...
Need help?
General
