Otto Bock 490E75 1 C Series User Manual

25
Getting in from the front
1) Turn the control device off.
2) Fold up the foot supports (see fig.25; item1).
If needed, swing the leg supports aside or remove
them (see page20).
3) Have an attendant assist you or use a transfer lifter
to get into and out of the power wheelchair.
4) Swing the leg supports in and fold down the foot
supports (see page20).
Getting in from the side (alternative option)
1) Turn the control device off.
2) Remove the side panel (see page17).
3) If needed: Remove the corresponding leg support
(see page20).
4) Get into or out of the power wheelchair from the
side. A ramp makes this easier.
5) Reinstall the leg support and side panel.
26
Getting in from the front
1) Turn the control device off.
2) Fold up the foot supports (see fig.26; item1).
3) If needed: Swing the posterior lower leg supports
to the side (see fig.26, item2).
4) Have an attendant assist you or use a transfer lifter
to get into and out of the power wheelchair.
5) Swing the posterior lower leg supports in and fold
down the foot supports.
Getting in from the side (alternative option)
1) Turn the control device off.
2) Remove the side panel (see page17).
3) If needed: Remove the corresponding leg support
(see page20).
4) Get into or out of the power wheelchair from the
side. A ramp makes this easier.
5) Reinstall the leg support and side panel.
7.6 Control unit
7.6.1 VR2 control unit
CAUTION
Risk of uncontrolled driving behaviour
Falling, tipping, collision with persons or nearby objects due to interference from electromagnetic fields
► Switch all mobile devices off while driving.
► Turn the control unit off when it is not needed.
The power wheelchair is controlled by a VR2 control unit.
Because the control unit is programmable, it can be adapted to the personal requirements of the user; e.g.the
speed, acceleration and deceleration values can all be adapted.
7.6.1.1 Control panel
The power wheelchair is operated using the control panel.
The control panel is divided into the keypad, two LED displays and the joystick. The charging/programming recept
acle is on the underside.
The control panel is used to switch the power wheelchair on and off, enter driving commands and display the cur
rent status of certain functions and components.
26
Use
490E75=1_C

Otto Bock 490E75 1 C Series Specifications

General

Brand	Otto Bock
Model	490E75 1 C Series
Category	Wheelchair
Language	English