7.7.8.2 R-Net control unit
INFORMATION
This function is currently not enabled.
For questions related to enabling it, please consult the qualified personnel that adapted the product or the manu
facturer's service (see inside back cover or back page for addresses).
The power wheelchair control unit features an electronic drive-away lock. This function is activated/deactivated via
the control panel.
Activating the drive-away lock
1) Press and hold the [On/off] button while the control device is turned on.
2) Release the [On/off] button after a beep sounds (approx. 1 second).
3) Push the joystick all the way forward until a beep sounds.
4) Push the joystick all the way back until a beep sounds.
→ A long beep confirms that the drive-away lock was activated.
→ The control device turns itself off.
→ The key symbol on the LCD screen indicates that the drive-away lock is activated:
Display Information
Drive-away lock
Deactivating the drive-away lock
1) Push the [On/Off] button on the control panel.
→ The control device is turned on. The LCD screen indicates that the drive-away lock is activated.
2) Push the joystick all the way forward until a beep sounds.
3) Push the joystick all the way back until a beep sounds.
4) Release the joystick.
→ A long beep confirms that the driving function is enabled.
→ The battery indicator and speed level are shown on the LCD screen.
→ The drive-away lock is deactivated and driving is enabled.
Activating the drive-away lock
1) Press and hold the [On/off] button while the control device is turned on.
2) Release the [On/off] button after a beep sounds (approx. 1 second).
3) Push the joystick all the way forward until a beep sounds.
4) Push the joystick all the way back until a beep sounds.
→ A long beep confirms that the drive-away lock was activated.
→ The control device turns itself off.
→ A sequential indicator on the [Selected speed level] LED display indicates that the drive-away lock is active:
Display Information
Sequential indicator on the "Speed levels"
LED display
Drive-away lock
Deactivating the drive-away lock
1) Push the [On/off] button on the control panel.
→ The control device is turned on. The [Selected speed level] LED display is in sequential indicator mode.
The [Charge level] LED display is off.
2) Push the joystick all the way forward until a beep sounds.
3) Push the joystick all the way back until a beep sounds.
4) Release the joystick.
→ A long beep confirms that the driving function is enabled.
→ The [Selected speed level] LED display and the [Charge level] LED display are lit up.
→ The drive-away lock is deactivated and driving is enabled.
62
Use
490E75=1_C
To Next Page
Loading...
Need help?
General
