Otto Bock 490E75 1 C Series User Manual

The control panel consists of buttons, LED displays and the joystick. The charging/programming receptacle is on
the underside.
The control panel is used to switch the power wheelchair on and off, enter driving commands and display the cur
rent status of certain functions and components.
1 [Charge level] LED display
2 [On/off] button
3 [Lights on/off] button
4 [Horn] button
5 [Mode] button
6 [Selected speed level] / [Selected profile] LED
display
7 [Increase speed] button
8 [Direction indicator right] button
9 Joystick
10 [Direction indicator left] button
11 [Decrease speed] button
12 [Selected seat function] LED display
13 [Warning flasher on/off] button
33
-- Charging/programming receptacle (on the back)
7.6.3.2 Buttons and display functions
Joystick
The speed and driving direction are controlled with the joystick (see page59).
If the control device is in "Power seat functions" mode, the seat function can be adjusted by moving the joystick
forwards/backwards (see page77) or switched to the next seat function by moving it left/right.
[On/off] button
Pressing this button turns the power wheelchair on or off (see page58). In combination with additional operating
steps, it also activates/deactivates the drive-away lock (see page61).
[Decrease speed] and [Increase speed] buttons
Pressing the button briefly increases/decreases the speed level (see page58).
Depending on the programming, the buttons can alternatively be used to select stored driving profiles. Up to five
driving profiles can be programmed.
[Mode] button
Pressing the button switches the control device to the programmed mode (e.g."Drive" mode or "Power seat func
tions" mode). When the control device is in the "Power seat functions" mode, the [Seat function] LED display
shows the active seat function (see next paragraph).
[Selected seat function] LED display
The LED display shows the currently selected seat function. When the LED display is active, the seat function can
be adjusted by moving the joystick forwards/backwards (see page77) or switched to the next seat function by mov
ing it left/right.
[Selected speed level] or [Selected profile] LED display
The LED display shows the currently selected speed level (1–5, see page58).
Depending on the programming, the LED display can alternatively show the selected driving profile (1–5).
If an automatic speed reduction (e.g.because a seat function was activated) is currently active, this is also dis
played here:
Display Information
Restricted speed (creep speed)
35490E75=1_C
Use

Otto Bock 490E75 1 C Series Specifications

General

Brand	Otto Bock
Model	490E75 1 C Series
Category	Wheelchair
Language	English