Otto Bock 490E75 1 C Series User Manual

[Primary control active] LED display
The red LED lights up when the attendant control is deactivated and the power wheelchair control panel is activ
ated.
[Mode] button
Pressing this button toggles through the programmed profiles and operating modes. The joystick is used to navig
ate within the profiles and operating modes (see above).
[Select Speed Level] button
Pressing the buttons increases/decreases the speed level. The acoustic signal changes when the maximum speed
level is reached.
[Selected speed level] LED display
The LEDs show the currently selected speed level (1–5).
Joystick
The attendant uses the joystick to control the speed and driving direction (see page59).
When the control device is in a seat mode, the seat option can be extended or retracted by moving the joystick for
wards/backwards (see page77).
[Activate/deactivate attendant control] button
The attendant uses this button to assume the control functions from the control panel or special control (if
installed). By pressing the button again, the attendant returns the control functions to the control panel or special
control. The respective state is shown by an LED indicator.
[Attendant control active] LED display
The green LED lights up when the attendant control is activated and the power wheelchair control panel is deactiv
ated.
[Primary control active] LED display
The red LED lights up when the attendant control is deactivated and the power wheelchair control panel is activ
ated.
[Mode] button
Pressing this button toggles through "seat function 1" > "seat function 2" > "seat function ..." in sequence. The
selected seat function is indicated by the LEDs. Pressing the button one more time returns to driving mode (seat
function LED display is not lit).
[Select speed level] button
Pressing the button increases/decreases the speed level. The acoustic signal changes when the maximum speed
level is reached.
[Selected speed level] LED display
The LEDs show the currently selected speed level (1–5).
Joystick
The joystick controls the speed and driving direction in the "Drive" profile (see page59).
If the control device is in "Seating" mode, the seat option can be operated by moving the joystick forwards/back
wards (see page77) or switched to the next seat option by moving it left/right.
You can navigate within the operating modes (e.g. "Bluetooth Device") by moving the joystick forwards/backwards
or right/left.
[Activate/deactivate attendant control] button
The attendant uses this button to assume the control functions from the control panel or TEN°LCD module. By
pressing the button again, the attendant returns the control functions to the control panel or special control. The
current state is shown by an LED indicator.
After the attendant control has been switched on, the LCD screen shows the following:
87490E75=1_C
Use

Otto Bock 490E75 1 C Series Specifications

General

Brand	Otto Bock
Model	490E75 1 C Series
Category	Wheelchair
Language	English