Pacific Power Source ADF Series - Page 236

ADF SERIES™ OPERATION MANUAL
SECTION 8:
Remote Control Programming
Entire Contents Copyright  2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
ADF Series Power Source Operation Manual Page 236 of 349
Command Syntax
SYSTem:COMMunicate:USB:LAN[:ENABle]
Description
Enables access to embedded webserver using virtual IP Address
through USB interface.
Parameters
< 0 | OFF | 1 | ON >
Parameter Format
<b>
Example
SYST:COMM:USB:ETH ON
Query Format
SYSTem:COMMunicate:USB:LAN[:ENABle]?
Returned Data Format
<b>
Query Example
SYST:COMM:USB:LAN?
1
Command Syntax
SYSTem:COMMunicate:USB:LAN:ADDress
Description
Sets the embedded webserver virtual IP Address for USB interface.
Parameters
< 0 | OFF | 1 | ON >
Parameter Format
<b>
Example
SYST:COMM:USB:LAN ON
Query Format
SYSTem:COMMunicate:USB:LAN:ADD?
Returned Data Format
<b>
Query Example
SYST:COMM:USB:LAN:ADD?
192.168.123.1
Command Syntax
SYSTem:COMMunicate:USB:LAN:APPly
Description
Applies IP settings for Virtual USB Lan interface.
Parameters
None
Parameter Format
N/A
Example
SYST:COMM:USB:LAN:APP
Command Syntax
SYSTem:COMMunicate:USB:LAN:MASK
Description
Sets the embedded webserver virtual IP Mask Address for USB
interface.
Parameters
IP Mask
Parameter Format
<cr>
Example
SYST:COMM:USB:LAN ON
Query Format
SYSTem:COMMunicate:USB:LAN:MASK?
Returned Data Format
<cr>
Query Example
SYST:COMM:USB:LAN:MASK?
255.255.255.0