ADF SERIES® OPERATION MANUAL
SECTION 5: UNPACKING AND INSTALLATION
Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
ADF Series Power Source Operation Manual Page 45 of 349
Figure 5-4: AC Input Terminal Block - Rear Panel
5.5 Grounding Requirements
5.5.1 Chassis Ground Connection Required
SHOCK HAZARD: Equipment must be grounded.
RISQUE DE CHOC: l´équipement doit être mis à la terre.
The unit MUST be grounded via the AC Input. A line cord with proper Earth Ground must be
used at all times. Correct grounding of your electrical system infrastructure according to
applicable national standards must also be observed.
To Next Page
Loading...
