Pacific Power Source ADF Series - Page 261

ADF SERIES™ OPERATION MANUAL
SECTION 8:
Remote Control Programming
Entire Contents Copyright  2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
ADF Series Power Source Operation Manual Page 261 of 349
Query Command
SYSTem:AIO:INput[n]:CALibration:OFFset:MINimum?
Returns lower limit of calibration coefficient value
Returned Data Format
<nr2>
Query Example
SYST:AIO:IN1:CAL:OFF:MIN?
1.000
8.10.4.2 SYSTem:AIO:OUTput#:CALibration
Command Syntax
SYSTem:AIO:OUTput[n]:CALibration:GAIN <nr2>
Description
Calibrates the full scale gain of the ADF parameter controlled
by the analog output.
Parameters
Reference
Parameter Format
<nr2>
Example
SYST:AIO:OUT1:CAL:GAIN 100.0
Query Format
SYSTem:AIO:OUTput[n]:CALibration:GAIN?
Returns calibration coefficient
Returned Data Format
<nr2>
Query Example
SYST:AIO:OUT1:CAL:GAIN?
1.000
Query Command
SYSTem:AIO:OUTput[n]:CALibration:GAIN:DEFault?
Returns default calibration coefficient value
Returned Data Format
<nr2>
Query Example
SYST:AIO:OUT1:CAL:GAIN:DEF?
1.000
Query Command
SYSTem:AIO:OUTput[n]:CALibration:GAIN:MAXimum?
Returns upper limit of calibration coefficient value
Returned Data
Format
<nr2>
Query Example
SYST:AIO:OUT1:CAL:GAIN:MAX?
1.000
Query Command
SYSTem:AIO:OUTput[n]:CALibration:GAIN:MINimum?
Returns lower limit of calibration coefficient value
Returned Data
Format
<nr2>
Query Example
SYST:AIO:OUT1:CAL:GAIN:MIN?
0.000