Panasonic DBS 40 - Page 59

Chapter 4. Trunks and Lines
Section 300~Installation
Trunk Assignments for Single-Cabinet Systems
l Programming is not required to associate trunk ports with slot locations.
However, you must use programming to
specify that a combination of Tl
and analog trunks are instailed, and you must also specify how many Tl
channels are used.
Table 4-9.
Tl and analog trunk assignments, DBS 40
Trunk
Number
using 16 Channels
Fractional T 1
using 8 Channels
1
I
Tl channel 16
I
Analog trunk 1 1
1 4.
.L
8
Tl channel 9
Analog trunk 8
9
L
16
Tl channel
8 Tl channel 8
1
.L
Tl channel
1 Tl channel 1
Note: Since the DBS 40 supports a maximum of 16 trunks, all 24 chan-
nels of the Tl cannot be used.
Table 4-10. Tl and analog trunk assignments, DBS 72
I
Trunk
Number
24Xhannel Tl Fractional Tl
using 16
Channels
Fractional
Tl
using 8 Channels
I
1 1 Tl channel 24 Analog trunk 1
Analog trunk 1
I
8 1 Tl channel 17 Analog trunk 8
Analog trunk 8
9
.L
16
17
-l-
24
Tl channel 16 Tl channel 16
Analog trunk 9
\1
L
.l.
Tl channel 9 Tl channel 9
Analog trunk 16
Tl channel 8
Tl channel 8
Tl channel 8
-L \1
L
Tl channel 1 Tl channel 1
Tl channel 1
4-14
DES Manual - Issued 8/l/95
DES-70-300
Technical Manuals Online! - http://www.tech-man.com