Chapter 4. Trunks and Lines
Section
300~Installation
Installation
The following procedures provide step-by-step instructions for installing the
Tl
Interface. The procedure that you should use depends on the type of
system you have and the number of Tls you are installing.
If you are installing . . .
1
Use
this
procedure...
1
A
Tl
in a single cabinet “Installing a
Tl
in a Single Cabi-
net” (page 4-21)
One
Tl
in a double cabinet, with the “Installing a
Tl
in a Single
Cabi-
Tl’
located in the master net” (page 4-21)
One
Tl
in a double cabinets, with the
“Installing a
Tl
in a Double
Cabi-
Tl
located in the slave
net with the
Tl
in the Slave”
(page 4-27)
Tls in both the master and slave
“Installing a
Tl
in a Double Cabi-
net with Tls in the Master and
Slave” (page 4-27)
4-20
DES
Manual
-
issued
8/l/95
DBS-70-300
Technical Manuals Online! - http://www.tech-man.com
To Next Page