Panasonic FP3 - Page 102

FP3 MEWNET-TR
Chapter7-2. Page.100
96
LED status Steps to take
x
Communications error
When operation mode selector No. 2 of the FP3 transmitter master unit is ON
(when the setting is made to allow continuing remote I/O control of properly
operating slave stations in the event of a communications error)
<Master station ERROR: ON, Slave station 1 POWER: OFF, COM.: OFF,
Other LEDs: normal status>
Slave station 1 Slave station 2
POWER COM. ALARM POWER COM. ALARM
No power supply
Master station
RUN
PROG.
TEST
BREAK
ERROR
BATT.
ALARM
COM.
ALARM
<FP3/FP10S
CPU>
<FP3
transmitter
master unit>
S
Check that power is
properly supplied to
slave station 1.
<Master station ERROR: ON, Slave station 2 COM.: OFF,
Other LEDs: normal status>
Slave station 1 Slave station 2
POWER COM. ALARM POWER COM. ALARM
Disconnection
Master station
RUN
PROG.
TEST
BREAK
ERROR
BATT.
ALARM
COM.
ALARM
<FP3/FP10S
CPU>
<FP3
transmitter
master unit>
S
Check the wiring
between slave
stations.
<Master station ERROR: ON, Slave station 2 COM.: OFF, ALARM: ON,
Other LEDs: normal status>
Slave station 1 Slave station 2
POWER COM. ALARM POWER COM. ALARM
Communications
error
Master station
RUN
PROG.
TEST
BREAK
ERROR
BATT.
ALARM
COM.
ALARM
<FP3/FP10S
CPU>
<FP3
transmitter
master unit>
S
Communications error
on slave station 2.
See page 101.
7-2. Remote I/O Control When an Error Occurs