Panasonic FP3

FP3 MEWNET-TR
Chapter7-2. Page.95
91
7-2. Remote I/O Control When an Error
Occurs
1. Operation Monitor LED Status
x Check the LED status of each unit of the FP3 MEWNET-TR system to judge the condition of the transmission cable
and each unit.
Note:
x
The LED status is indicated as follows.
:ON
: OFF
: Flashing (in approx. 0.2 s intervals)
: Flashing slowly (in approx. 1 s intervals)
1) When the power for each unit is turned ON
J
Normal condition
x FP3/FP10S CPU
(RUN: OFF, PROG.: ON, TEST, BREAK, ERROR, BATT. and ALARM: OFF)
x FP3 transmitter master unit
(COM.: Flashing, ALARM: OFF)
x Slave stations 1 and 2
(POWER: ON, COM.: Flashing, ALARM: OFF)
POWER COM. ALARM POWER COM. ALARM
Master station
Slave station 1
(FP I/O
transmitter unit)
Slave station 2
(FP I/O
transmitter unit)
RUN
PROG.
TEST
BREAK
ERROR
BATT.
ALARM
COM.
ALARM
<FP3/FP10S
CPU>
<FP3
transmitter
master unit>
7-2. Remote I/O Control When an Error Occurs