FP3 MEWNET-TR
Chapter3-1. Page.33
29
3) Unit installation
x Before installing the unit, remove the connector cover on the master or expansion backplane.
<Procedure>
1. Fit the unit tabs into the unit holes on
the backplane.
2. Push the unit in the direction of the arrow
to plug it onto the backplane.
3. After properly plugging the unit into the
backplane, secure the mounting screw at
the top
Notes:
x
Be sure to turn the power supply OFF before installing or removing the units.
x
Be careful not to use unreasonable force when plugging the connector on the unit into the connector on the
master or expansion backplane.
3-1. Installation
Tab
Hole
Master or
expansion backplane
Connectors
Screwdriver
To Next Page
Loading...
