Panasonic FP3

FP3 MEWNET-TR
Chapter4-1. Page.57
53
x
Selector number 4:
Terminal station setting of the slave station
Set the selector to ON when the slave station is the terminal station, and set it to OFF when
the slave station is not the terminal station.
Example:
Master
station
Slave
station 1
Slave
station 2
Slave
station 3
Terminal station
Terminal station
Because neither slave station 1 nor 2 is the terminal
station, set selector number 4 of these units to OFF.
Because slave station 3 is the
terminal station, set selector
number 4 of this unit to ON.
2) Operation mode when shipped
x The operation mode selector numbers of the slave station (FP I/O transmitter unit) are all set to the OFF position when
shipped.
x Operation mode setting of the FP I/O transmitter unit when shipped:
- The setting disallows the use of the unit as a slave station of a MEWNET-TR system.
- When the transmission cable disconnects during output operation, the output turns OFF.
- The unit is not set for use as the terminal station.
4-1. Operation Mode Setting