FP3 MEWNET-TR
Chapter3-1. Page.38
34
2) Mounting method
J
Panel mount
Mount the slave station to the panel with M4 size screws as follows.
W
H
2-M4 or 2-dia. 5
<Mounting hole dimensions>
Type W (mm/in.) H (mm/in.)
FP I/O
4 I/O points
66/2.598 35/1.378
transmitter unit
8 I/O points
100/3.937 35/1.378
16 I/O points
170/6.693 35/1.378
Expansion FP I/O
8 I/O points
100/3.937 35/1.378
terminal unit
16 I/O points
170/6.693 35/1.378
J
DIN rail mount
To mount the slave station (FP I/O transmitter unit and expansion FP I/O terminal unit) on a DIN rail, use the attachment
lever that is attached to each unit.
DIN rail
DIN rail
Attachment lever
Claw
Slotted screwdriver
x
Attachment
Alignthe slavestation withthe DINrailgrooveand
push the unit down to install it.
(
Example:
FP I/O transmitter unit)
x
Removal
To remove the slave station from the DIN rail, pull the
attachment lever down with a slotted screwdriver.
(
Example:
FP I/O transmitter unit)
3-1. Installation
To Next Page
Loading...
