Panasonic FP3

FP3 MEWNET-TR
Chapter8-3. Page.125
121
2) FP I/O transmitter unit
Operation mode selector
OFF
ON
1234
Selector
Function
Description
Selector position
S
e
l
e
c
t
o
r
number
F
unc
ti
on
D
escr
i
p
ti
on
1 2 3 4
1
Communication
d
lti
(1:1)
×
n communication ON
mode selection
1:1 communication OFF
2
System configuration
selection
This unit is regarded as a slave
station.
ON
This unit is not regarded as a slave
station.
OFF
3
Output operation
condition
during
Hold (continues I/O communication) ON
con
diti
on
d
ur
i
ng
a communication error
Output OFF OFF
4
Terminal station setting Terminal station ON
Not a terminal station OFF
Notes:
x
The operation mode selectors are all set to the OFF position when shipped.
x
The operation mode selector’s upper state is “ON ( )” and the lower state is “OFF ( ).”
x
Be sure the power is OFF when changing the switch position.
2. Station Number Selector
x The I/O numbers to be allocated to each slave station are determined by the slave station number setting.
Since each I/O number is assigned to a single slave station number, set each slave station with the slave station number
that corresponds to the I/O numbers you wish to allocate.
x To set aslavestation number,turnthe station number selector of the FP I/O transmitterunit using a slottedscrewdriver.
Example:
Setting station number 2
Set “2”.
Station
number
selector
Slotted
screwdriver
8-3. Settings