FP3 MEWNET-TR
Chapter5-2. Page.77
73
5-2. Procedure Up to Trial Operation
1. Trial Operation Procedure
x After installation and wiring, perform a trial operation according to the following procedure.
FP I/O
transmitter unit
FP I/O
transmitter unit
POWER COM. ALARM POWER COM. ALARM
Slave station
Master station
: ON : OFF : Flashing (in approx. 0.2 s intervals)
START
END
S
We recommend that the created program be saved onto a floppy disk, onto
EEPROM for the FP3C CPU (AFP3210C, AFP3211C, and AFP3220C), and
onto an IC memory card for the FP10S CPU (AFP6231).
Printing out is also possible.
1. Turn the power ON.
S
Before turning the power ON, check the items described on the previous page.
S
Turn ON the slave stations (FP I/O transmitter units) first, then turn ON the
master station (Power supply unit).
S
After the power is turned ON, check that the LED indication on each unit is as
shown below. If the LEDs do not light in the same manner shown below, there
is a communication error. See page 91, “7-2. Remote I/O Control When an
Error Occurs.”
2. Programming
S
Check the I/O addresses allocated to each slave station.
S
Enter the program with the NPST-GR or FP Programmer
II
.
S
When using the FP Programmer
II
, be sure to perform the “Clear Program”
operation before inputting.
S
Use the programming tool’s total check function to check for syntax errors.
3. Verify the output wiring.
S
Check the output wiring by using the forced ON/OFF function.
4. Verify the input wiring.
S
Check the input wiring by watching the ON/OFF status of the input LEDs.
5. Begin trial operation.
S
Switch the mode selector from PROG. mode to RUN mode, and verify that the
RUN LED turns ON.
S
Check the sequence operation of the program.
6. Debugging
(program correction)
S
If there is an error in the operation, check the program using the programming
tool’s monitor function.
S
Correct the program.
7. Save the program.
<FP3 MEWNET-TR System>
RUN
PROG.
TEST
BREAK
ERROR
BATT.
ALARM
COM.
ALARM
CPU
FP3 transmitter
master unit
5-2. Procedure Up to Trial Operation
To Next Page
Loading...
