FP3 MEWNET-TR
Chapter1-4. Page.14
10
3. Controllable I/O Points and I/O Allocation
x The I/O allocation example shown in the table below is for an FP3 transmitter master unit installed in slot No. 0 of the
master backplane.
x The open circles (
f
) indicate the number of points used for input, and the closed circles (
F
) indicate the number of
points used for output.
< Example >
When 32 input points and 32 output points are selected, the input point numbers are X0 to X1F, and the
output point numbers are Y20 to Y3F.
Requested I/O point I/O allocation
Input Output
0
to
F
10
to
1F
20
to
2F
30
to
3F
40
to
4F
50
to
5F
60
to
6F
70
to
7F
80
to
8F
90
to
9F
100
to
10F
110
to
11F
120
to
12F
130
to
13F
140
to
14F
150
to
15F
128
f f f f f f f f F F F F F F F F
64
f f f f f f f f F F F F
128
32
f f f f f f f f F F
16
f f f f f f f f F
0
f f f f f f f f
128
f f f f F F F F F F F F
64
f f f f F F F F
64
32
f f f f F F
16
f f f f F
0
f f f f
128
f f F F F F F F F F
64
f f F F F F
32
32
f f F F
16
f f F
0
f f
128
f F F F F F F F F
64
f F F F F
16
32
f F F
16
f F
0
f
128
F F F F F F F F
64
F F F F
32
F F
16
F
Notes:
x
The I/O points used in a MEWNET-TR system are selected by the operation mode selector of the FP3
transmitter master unit.
x
The first I/O numbers vary depending on the mounting position of the FP3 transmitter master unit and the
I/O occupation points of other units installed.
1-4. Combinations
To Next Page
Loading...
