Panasonic FP3 User Manual

CONTENTS
FP3 MEWNET-TR
CONTENTS Page.2
3. Wiring the I/O Terminal Power Supply of the Slave Station 38.............
1) Internal circuit diagram 38......................................
2) Wiring the power supply 38.....................................
3) Recommended crimp 39.......................................
4) Wiring input 39..............................................
5) Wiring output 42.............................................
4. Wiring Using the Transmission Cable 43..............................
1) Wiring a master station and a slave station 43.......................
2) Wiring a slave station and a slave station 43........................
3) Wiring layout 44.............................................
4) Grounding 45................................................
5) Transmisson cable 45..........................................
6) Notes on wiring 45............................................
5. Slave Station Expansion 46.........................................
1) Connecting a slave station and an expansion unit 46..................
2) Connecting method 46.........................................
3) Combination of units 47........................................
CHAPTER 4: OPERATION MODE SETTING AND
I/O ALLOCATION
4-1. Operation Mode Setting 50...........................................
1. Master Station 50.................................................
1) Operation mode selector setting 50...............................
2) Operation mode when shipped 51................................
2. Slave Station 52..................................................
1) Operation mode selector setting 52...............................
2) Operation mode when shipped 53................................
3. Operation Mode Setting When an Error Occurs 54.......................
1) Communication error 54.......................................
2) I/O control operation condition when a communication error occurs 54..
3) Output condition when a communication error occurs 56..............
4-2. I/O Allocation 57...................................................
1. I/O Allocation and Station Number Setting 57..........................
1) I/O numbers allocated to slave stations 59..........................
2) Setting station numbers 60......................................
3) I/O allocation method 61.......................................
2. I/O Allocation When Using Expansion Units 62.........................
1) I/O allocation of expansion FP I/O terminal units 63.................
3. I/O Allocation Table 64............................................
CHAPTER 5: BEFORE TRIAL OPERATION
5-1. Things to Check Before Turning the Power ON 72.........................
5-2. Procedure Up to Trial Operation 73.....................................
1. Trial Operation Procedure 73........................................
2. Checking the Communication Condition of the Slave Stations 74...........

Panasonic FP3 Specifications

General

Brand	Panasonic
Model	FP3
Category	Controller
Language	English