• The default of OGM floating extension numbers depends on system programming. For more
information, consult your System Administrator or System Manager.
2.1.6 Allowing Users to Seize an Unavailable Outside Line
(Trunk Busy Out)
When a problem is found on a certain outside line, the PBX automatically makes it unavailable for use
temporarily. The manager can manually enable the outside line and allow users to use it again.
To re-enable an outside line
Off-hook.
7
On-hook.
8 5
Enter outside line number
(3 digits).
outside line no.
C.Tone
Enter 785.
PT/SLT/PS
• In some countries/areas, the PBX may not be able to automatically make a faulty outside
line unavailable for use.
2.1.7 Releasing Network Direct Station Selection (NDSS) Monitor
NDSS buttons can be customised on any extension connected to your PBX. An
NDSS button allows an extension user to monitor another extension connected to
another PBX in a private network. The NDSS button light shows the current status of
the monitored extension in the same way as a DSS button. When it becomes
unnecessary to monitor an extension connected to another PBX, the manager can
stop the PBX from monitoring it. Any NDSS buttons set to monitor that extension will
also stop monitoring.
PT/PS
Off-hook.
(NDSS)
Dial another PBX extension
number and then enter #, or
press NDSS.
another PBX
extension no.
OR
C.Tone
On-hook.
Enter 784.
7 8 4
• To restart monitoring of an extension after performing this operation, go off-hook, press the
corresponding NDSS button, and go on-hook.
2.1.6 Allowing Users to Seize an Unavailable Outside Line (Trunk Busy Out)
Operating Manual 245
To Next Page
Loading...
