To set/cancel
PT/KX-UT series
Press SP-PHONE.
During a conversation using the handset
• The SP-PHONE button light shows the current status as follows:
Off: The voice is heard through the handset.
On: The voice is heard through the speaker and the handset.
• This feature requires system programming.
• Hands-free operation
You can have a conversation in hands-free mode using the SP-PHONE button. You can
perform other tasks simultaneously.
• Helpful hints for hands-free operation:
– If it is difficult to hear the other party’s voice,
Increase the volume using the Navigator Key or Volume Key.
– If the other party has difficulty hearing you,
Decrease the volume.
– If the other party reports that your voice echoes,
Use the telephone in a room that has curtains, carpeting or both.
– If parts of the conversation cannot be heard,
If you and the other party speak at the same time, parts of your conversation may be lost.
To avoid this, try to speak alternately.
1.4.8 Using the Headset (Headset Operation)
You can have a conversation using a headset.
In this case, you must select "Headset on" in programming mode or set the Headset
button on (red) in advance. However, for the KX-UT113/KX-UT123 and S-PS, Headset
mode is enabled automatically when a headset is connected to the headset jack of the
telephone.
This feature is also known as Handset/Headset Selection.
To talk using the headset
PT/KX-UT series
Press SP-PHONE.
1.4.8 Using the Headset (Headset Operation)
90 Operating Manual
To Next Page
Loading...
