2. To set the flexible buttons, specify each button on the
Flexible Button screen.
Follow the table below to set each parameter. When
you finish, click OK.
Button Steps
Loop-CO (L-CO)
Select Loop CO from Type.
To specify the ring tone, select the ring tone type from Optional
Parameter (Ringing Tone Type Number).
Group-CO (G-CO)
Select Group CO from Type.
Then specify the outside line group number in Parameter Selection.
To specify the ring tone, select the ring tone type from Optional
Parameter (Ringing Tone Type Number).
Single-CO (S-CO)
Select Single CO from Type.
Then specify the outside line number in Parameter Selection.
To specify the ring tone, select the ring tone type from Optional
Parameter (Ringing Tone Type Number).
Direct Station Selection (DSS)
Select DSS from Type.
Then enter the extension number in Extension Number.
One-touch Dialling
Select One-touch from Type.
Then enter the desired number in Dial (max. 32 digits consisting of 0–9,
, #, T [Transfer], [ ] [Secret], P [Pause], and F [Flash]).
Note
• If you store an outside party’s number, you should first store a
line access number.
If you need to enter an account code, you can enter the specified
account code before the line access number.
<Example>
Account
code
1234
Account code
delimiter
#
Automatic line
access number
0/9
Phone number
SECRET
[ 123 4567 ]
Account code
feature no.
49
• For KX-UT series SIP phones and S-PS users:
Use only 0–9, , and # for One-touch Dialling buttons. If
characters other than these are stored, they will be considered
invalid. Only the digits up to an invalid character will be sent
when using that One-touch Dialling button.
Incoming Call Distribution
Group (ICD Group)
Select ICD Group from Type.
Then enter the incoming call distribution group extension number in
Extension Number.
To specify the ring tone, select the ring tone type from Optional
Parameter (Ringing Tone Type Number).
Message Select Message Waiting from Type.
3.2.1 User Programming
314 Operating Manual
To Next Page
Loading...
