To disconnect one party and then talk to the other in a three-party conversation
PT/PS
Press TRANSFER once
or twice to establish a
conversation with the
party to be disconnected.
During a conversation
Press FLASH/RECALL.*
Press the flashing CO, ICD Group,
PDN, SDN, or INTERCOM
corresponding to the party on hold.
Talk.
The other party will be put on hold.
OR
(CO)
(ICD Group)
OR
(SDN)
(PDN)
OR
OR
• * In this case, the FLASH/RECALL button on a proprietary telephone must be set to Flash/
Recall mode through system programming.
• During a three-party conversation, pressing the TRANSFER button or Recall/hookswitch
alternates between the other parties in the conversation.
• You can have a conference with a maximum of eight parties (comprising intercom or outside
lines) simultaneously.
• During a conversation involving four or more parties, you cannot disconnect one party and
maintain the conversation with the other parties.
• Non-KX-UT series SIP phone users cannot originate a conference call, but can be added as
a member.
• When a KX-UT series SIP phone or S-PS user originates a conference call and one of the
other parties leaves the conference, the KX-UT series SIP phone or S-PS user will still be
able to talk to the remaining party but will not be able to hold the call.
Customising Your Phone
• 3.1.3 Customising the Buttons
Create or edit a Conference button.
Leaving a Conference (Unattended Conference)
The person who originated a conference can leave the conference, and allow the
other parties to continue the conversation.
• KX-UT series SIP phone and S-PS users: If you originated a conference, you cannot leave
the conference and allow the other parties to continue the conversation. When you go on-
hook, the conference is terminated and the other parties are disconnected.
1.4.5 Multiple Party Conversation
84 Operating Manual
To Next Page
Loading...
