Panasonic KX-NS1000 - Page 99

To set the timer for "No Answer" and "Busy/No Answer"
Off-hook.
Enter time
(seconds [2 digits]).
time
PT/SLT/PS/SIP Extn./S-PS
Enter 713.
On-hook.
1 3 7
C.Tone
To set/cancel (Call Forwarding [FWD] for your Incoming Call Distribution Group)
PT/SLT/PS/SIP Extn./S-PS
0
1
Set
Cancel
OR
Enter 1 to set
or 0 to cancel.
Enter ICD Group
extension number.
ICD Group
extension no.
Off-hook.
5
6
4
Both Calls
Intercom Calls
Outside Calls
OR
OR
Enter 71.
17
Enter 4 to 6 as
you desire.
Enter #.
On-hook.
Enter destination extension number.
Or enter outside line access number
and then outside phone number.
OR
(max. 32 digits)
outside
phone no.
outside line
access no.
C.Tone
ICD Group: Incoming Call Distribution Group
For "Cancel", go on-hook
directly after entering ICD
Group extension number.
destination
extension no.
• For KX-UT series SIP phones (except KX-UT670), when Call Forwarding or Do Not Disturb
is enabled, FWD/DND appears on the display in stand-by mode. For KX-UT670, when Call
Forwarding or Do Not Disturb is enabled, a status icon appears on the display. For details,
refer to the documentation for your phone.
• The FWD/DND button light shows the current status as follows:
Off: Both features are not set.
Red on: FWD mode
Flashing red slowly: DND mode
For KX-UT series SIP phones, you can see the current status on the display.
• The Group FWD button light shows the current status as follows:
Off: No set
Red on: FWD mode
1.6.1 Forwarding Calls
Operating Manual 99