Panasonic KX-TDA30

2.13 Starting the Hybrid IP-PBX — KX-TDA100/KX-TDA200
200 Installation Manual
2.13 Starting the Hybrid IP-PBX — KX-TDA100/
KX-TDA200
2.13.1 Starting the Hybrid IP-PBX
CAUTION
• SD Memory Card must be inserted in the SD Memory Card slot of the MPR card
before start up.
• Before touching the System Initialise Switch and the Reset Button, discharge static
by touching ground or wearing an earthing strap.
• Once you have started the Hybrid IP-PBX and if you unplug the Hybrid IP-PBX, do
not perform the following procedures to start the Hybrid IP-PBX again. Otherwise,
your programmed data is cleared. To restart the Hybrid IP-PBX, refer to "4.1.4 Using
the Reset Button".
• The Hybrid IP-PBX will continue to be powered even if the power switch is turned
"OFF".
• The power supply cord is used as the main disconnect device, ensure that the socket-
outlet is located/installed near the equipment and is easily accessible.
1. Set the System Initialise Switch to the "SYSTEM INITIALIZE" position.
System Initialise Switch
Reset Button
SYSTEM
INITIALIZE
RESET
NORMAL
RUN Indicator