Panasonic KX-TDA30

6.12 Starting the Hybrid IP-PBX — KX-TDA30
386 Installation Manual
6.12 Starting the Hybrid IP-PBX — KX-TDA30
6.12.1 Starting the Hybrid IP-PBX
CAUTION
• SD Memory Card must be inserted in the SD Memory Card slot of the main board
before start up.
• Before touching the System Initialise Switch and the Reset Button, discharge static
by touching ground or wearing an earthing strap.
• Once you have started the Hybrid IP-PBX and if you unplug the Hybrid IP-PBX, do
not perform the following procedures to start the Hybrid IP-PBX again. Otherwise,
your programmed data is cleared. To restart the Hybrid IP-PBX, refer to "8.1.4 Using
the Reset Button".
• The Hybrid IP-PBX will continue to be powered even if the power switch is turned
"OFF".
• The power supply cord is used as the main disconnect device, ensure that the socket-
outlet is located/installed near the equipment and is easily accessible.
1. Set the System Initialise Switch to the "SYSTEM INITIALIZE" position.
Reset Button
System Initialise Switch
RUN Indicator
ALARM Indicator