6.2 Installation of the Hybrid IP-PBX — KX-TDA30
262 Installation Manual
2. Position the card in the open slot, making sure that the tabs on the both sides of the card
fit into place. Then, holding the card firmly in place, lower the rear end so that the hole of
the card fits over the extension bolt.
CAUTION
When installing the optional service cards, do not put pressure on any parts of the main
board. Doing so may result in damage to the Hybrid IP-PBX.
3. Insert the new extension bolt (included with the card) into the hole on the card, and tighten
it to secure the card.
1
2
Extension Bolt
Optional Service Card
Extension Bolt
To Next Page
Loading...
