6.12 Starting the Hybrid IP-PBX — KX-TDA30
Installation Manual 389
LED Indications
Confirming the Trunk Connection
After initialisation, programme the Hybrid IP-PBX and establish trunk connection, and then use
a PT to confirm it.
To confirm, dial [ ] [3] [7] + trunk number (3 digits) or press S-CO button. You will hear a dial
tone if the trunk is available and connected.
Turning off the Hybrid IP-PBX
For safety reasons, make sure to turn off the power switch before unplugging the Hybrid IP-
PBX. To unplug, follow the reverse steps to plug it in.
Indication Colour Description
RUN Green PBX status indication
• OFF: Power Off (includes normal reset)
• ON: Power On and running (on-line)
• Flashing (60 times per minute): Starting up
• Flashing (120 times per minute): Starting up or resetting with:
• the System Initialise Switch in "SYSTEM INITIALIZE"
position
• the SD Memory Card not inserted
ALARM Red Alarm indication
• OFF: Normal
• ON: Alarm (CPU stop, alarm for each card)
• Flashing: Alarm (MPR file error in restarting)
To Next Page
Loading...
